Page 1 of 12

Journal for Studies in Management and Planning

Available at http://internationaljournalofresearch.org/index.php/JSMaP

e-ISSN: 2395-0463

Volume 01 Issue 04

May 2015

Available online: http://internationaljournalofresearch.org/ P a g e | 170

Characterization of the water used for ablution,

household and washing purposes in AlQurayyat, KSA

Ahmed M. El-Naggar1

, Fahd S. Al-Anzi1

, Badr K. Al-Ruwaili1

, Saif S. Al-Anzi2

, Fares M. Al- Ruwaili2

1

Department of Applied Medical Sciences, Community College in Al-Qurayyat, Al-Jouf University, KSA

Department of Physical Therapy and Rehabilitation, Faculty of Applied Medical Sciences

in Al-Qurayyat, Al-Jouf University, KSA2

ABSTRACT

The objective of the present

investigation is to assess the quality of the

water employed in three purposes, namely

ablution, household and washing, ascertain

the contamination problems that may

confront the consumers, and suggest

convenient reforms. The present study aims

also to enhance community participation in

the operation and maintenance of water and

sanitation facilities and to rationalize the use

of water. Nine ablution water, 7 household

water and 3 washing water samples were

randomly selected from different districts of

AlQurayyat. Out of 19 examined water

samples, 6 ablution water and 3 household

water samples were contaminated with

bacteria. However, water used in restaurants

was free of bacteria. The pH values were

located on the weak alkaline scale. Data

recorded indicate that 5 ablution water

samples, 2 restaurant water samples and

only one household water sample attained

TDS levels over 2000 mg/L. Other studied

water samples were freshwater; their

TDS levels ranged between 460 and 570

mg/L. The vast majority of the studied water

samples showed relatively high levels of

sulphate salts. The studied water samples

were either slightly chlorinated or non- chlorinated. They were clear or murky,

indicating variable degrees of

turbidity/transparency among studied water

samples. Nitrates showed marked variability

among studied water samples. The

maximum nitrate level was recorded for

ablution water (12.2 mg/L), while the

minimum value was documented for the

same water type (0.6 mg/L). Data obtained

revealed that nitrite levels were safe.

INTRODUCTION

Meeting the water demand of the

progressively growing population is the

greatest challenge facing the government in

Saudi Arabia as well as in other arid and

semi-arid countries worldwide (Al-Zahrani

Page 2 of 12

Journal for Studies in Management and Planning

Available at http://internationaljournalofresearch.org/index.php/JSMaP

e-ISSN: 2395-0463

Volume 01 Issue 04

May 2015

Available online: http://internationaljournalofresearch.org/ P a g e | 171

and Khodran, 2009, 2010). According to the

estimations of Al-Saud et al. (2011), the

overall water consumption in KSA is

approximately 611 m3

per second, 444m3

of

which (73%) are mined from non-renewable

water sources, namely groundwater aquifers.

Groundwater supplies a large proportion of

water globally (Gleeson et. al., 2013).

Groundwater aquifers have an enormous

storage capacity and are regarded as the

most relevant source of the clean, freshwater

in countries facing the threats of water

scarcity. Unfortunately, the supply of

groundwater is regularly decreasing, with

depletion occurring most prominently in

Asia and North America (Gleeson et. al.,

2013).Over the last decades, climatic

changes led to a dramatic depletion of the

renewable surface water. Poor management

policies and water consumption behavior

have deprived the community of such

enormous amounts of water. About two

billion people depend merely upon aquifers

for drinking water, and 40% of the world’s

food (Morris et. al., 2003).

The World Bank (2000) highlighted

the diverse water challenges in the Islamic

World. About 10 to 30% of the water losses

are contributed to leakage from faucets,

toilets, or plumbing fixtures in homes,

mosques, governmental buildings and public

institutions. Therefore, detecting and

repairing leaking fixtures forms a good

starting point for efficiency improvements.

Regular maintenance of water resources and

routine check of water facilities can save

huge amounts of water to be employed in

many purposes. Detecting water leaks in the

commercial and institutional buildings needs

continuous monitoring, overnight

monitoring, and water balances to determine

the level of leakage. Nowadays, the world is

shifting to keep balance between the water

supply and demand through the management

of water demand to achieve fair and

effective utilization of water.

The present study aims to evaluate

the physicochemical and bacteriological

properties of the water employed in three

purposes, namely ablution water, household

water and washing water in restaurants of

AlQurayyat. One of the objectives of the

present study is to raise the awareness of the

population about the community

participation in the maintenance of natural

water resources and the reduction of water

usage in order to overcome the water crisis

and keep water for the future generations.

MATERIALS AND METHODS

Nine ablution water, 7 household

water and 3 washing water samples were

Page 3 of 12

Journal for Studies in Management and Planning

Available at http://internationaljournalofresearch.org/index.php/JSMaP

e-ISSN: 2395-0463

Volume 01 Issue 04

May 2015

Available online: http://internationaljournalofresearch.org/ P a g e | 172

collected from different districts of

AlQurayyat. Water samples were collected

and processed according to the method

described in El−Naggar et al. (2015).

Chemical and bacteriological tests were

conducted at the laboratory of the water

purification plant in AlQurayyat. Data were

pooled to highlight the most common

features of each studied brand of water.

Total suspended solids (TSS) were

determined following Al-Mughalles et al.

(2012).A sterile, dry filter paper was

weighed (W1) and then placed on a vacuum

flask. 25 ml of the water sample was

dropped gently on the filter paper and a

suction pump was used to draw water across

the filter. The filter paper was then

transferred to a drying oven at 105°C

temperature for few minutes. The filter

paper holding solids was reweighed (W2)

and the net weight of the total suspended

solids was calculated according to the

following formula: [(W2 – W1) / 25]  106

.

HACH DR/5000 Portable

Spectrophotometer is the instrument was

used for the measurement of ammonia,

nitrate, nitrite, phosphate, iron, sulphate and

total chlorine. To determine the level of

ammonia in the studied water samples, 0.1

ml of the target water brand was gently

transferred in a clean and dry test tube and

two reagents, namely ammonia salicylate

and ammonia cyanurate were added. A

blank sample was prepared by mixing 0.1 ml

of distilled water with the above mentioned

reagents under similar conditions. To

estimate the value of nitrates in water, 1 ml

of each sample was injected in nitrate

reagent test tube and the instrument was

zeroed on the sample itself before reagent

addition. Nitrate reagent was added, then the

sample was put in the instrument and the

readings were taken after five minutes. An

amount of 25 ml of the waster sample was

placed in a glass cell and the same amount

of distilled water was put in another cell to

be the blank. 1 ml of two reagents, namely

Molybdate and Amino acid were added to

each cell.

RESULTS

Data concerning the

physicochemical and bacteriological

properties of the studied water types are

recorded in Tables 1, 2 and 3, respectively.

Figures 1, 2 and 3 show the levels of total

dissolved solids (TDS), turbidity and nitrates

in ablution water, respectively. It could be

noticed from Tables 1, 2 and 3 that the pH

values are located on the weak alkaline

scale. Except for a moderate alkaline (pH =

8.36) water sample collected from the

washing basin of a restaurant, all the studied