Page 1 of 10
European Journal of Business &
Social Sciences
Available at https://ejbss.org/
ISSN: 2235-767X
Volume 07 Issue 04
April 2019
Available online:https://ejbss.org/ P a g e | 1440
Performance Analysis of Multilevel Inverters Fed
Induction Motor
ANANTHAM .M
PG Student,
PRIST Deemed to be University, Thanjavur
Abstract - With the increasing concerns on energy issues, the
development of renewable energy sources is becoming more and
more attractive. A new kind of wind-PV hybrid generated system
that comprises of wind and photovoltaic generation subsystems as
input to a cascaded H-bridge multilevel inverter is developed in
this paper. In conventional methods the inverter with solar and
wind energy sources are used. In this method a seven level
multilevel inverter with wind–PV hybrid generation system as
input are proposed for application to remote and isolated areas.
The wind and the solar light are captured in greatest degree, as
well as the multilevel inverter using pulse width modulation
technique is adopted. The objectives of this hybrid system are, to
satisfy the load power demand and, presence of high number of
output levels in inverter to maintain the dc output voltage level of
the inverter to produce a nearly sinusoidal output. This reduces
harmonics in inverter output voltage. This paper discusses about
the control of seven-level H-bridge cascaded multilevel inverter
with Fast Fourier Transform analysis in inverter output voltage
through simulation. The simulated wind-PV system consists of an
AC-to-DC boost converter, a DC-to-AC inverter, a photovoltaic
module, and wind module. Its shown by the simulations that a
multilevel inverter utilizing renewable resource has lower Total
Harmonics Distortion in output voltage. In this paper comparison
of conventional inverter and proposed seven level cascaded H- bridge multilevel inverter using solar and wind energy sources are
presented.
Keywords-Harmonics, MATLAB, Pulse Width Modulation
(PWM), PhotoVoltaic array (PV), Wind Turbine
I. Introduction
The demand for renewable energy has increased
significantly over the years because of shortage of fossil fuels
and greenhouse effect. Among various types of renewable
energy sources, solar energy and wind energy have become
very popular and demanding due to advancement in power
electronic techniques. Solar technologies tap directly into the
infinite power of the sun and use that energy to produce
Page 2 of 10
European Journal of Business &
Social Sciences
Available at https://ejbss.org/
ISSN: 2235-767X
Volume 07 Issue 04
April 2019
Available online:https://ejbss.org/ P a g e | 1441
heat, light and power. Wind is one of the most environment
friendly, clean and safe energy resources.
The development of solar power generation should be
integrated with that of the wind power generation systems
since both forms of renewable energy have inherently
random property and they can compensate the lack of
energy for each other. Hence, the hybrid wind -PV power
system therefore has higher reliability to deliver continuous
power than either individual source.
Usually, two separated inverters for the PV array and
the wind turbine are used for the hybrid wind-PV power
system. An alternative approach is to use the multilevel
inverter for combining these renewable energy sources in
the dc end instead of the ac end. It can simplify the hybrid
wind-PV power system and reduce the costs. This paper is
focused on hybrid inter connection of solar and wind
source for seven level multilevel inverter control.
II. Conventional Inverter Topology
The general structure of the inverter for single phase
output is shown in Figure 1and the output voltage of the
inverter is shown in Figure 2. The voltage source Vdc1
connected as shown in Figure1 and this circuit consists of four
active switching elements that can make the output voltage
source in positive or negative polarity; or it can be simply zero
volts depending on the switching condition of the switches in
the circuit [1-3]. A conventional inverter topology employs
multiple link voltage of equal magnitudes. It is fairly easy to
generalize the number of distinct levels.
Fig. 1 Topology for conventional inverter
Page 3 of 10
European Journal of Business &
Social Sciences
Available at https://ejbss.org/
ISSN: 2235-767X
Volume 07 Issue 04
April 2019
Available online:https://ejbss.org/ P a g e | 1442
Fig. 2 Output voltage of conventional inverter
III. Proposed Multilevel Inverter Topology
The proposed seven level multilevel inverter block with
wind and photovoltaic generation systems as input sources
block diagram is shown in Figure 3. The block diagram
consists of a boost DC–DC converter and a full bridge DC– AC
inverter. The DC-DC converter can draw maximum power
from both the PV array and the wind turbine. Diode rectifier is
used at the wind output to convert ac power obtained from
wind module into dc power to be fed to the DC-DC converter.
Two cascaded H-bridge inverters are used. Each H-bridge is a
standalone bridge with the necessary signal conditioning/
processing circuitry and gate drivers.
Traditionally, each phase of a cascaded multilevel
inverter requires n dc sources for 2n + 1 level, where n is the
number dc sources. This paper allows the use of a single dc
source such as solar cell as the first dc source with the
remaining dc source being wind for the cascaded H-bridges
multilevel inverter. Seven level output voltage will be
regulated by the DC/AC inverter. Multilevel inverter is
powered by wind-PV and is capable of achieving seven
level stepped output phase voltage with a refined harmonic
profile. The output waveform quality will be improved due
to the increased number of levels. Improving the output
waveform of the inverter reduces its respective harmonic
content and, hence, the size of the filter used and the level of
electromagnetic interference EMI generated by switching
operation of the inverter.
Fig. 3 Block Diagram of Seven Level Multilevel Inverter with PV and
Wind as Input Sources
